Meat display cabinet IGLOO PRXNW45

An inside-corner refrigerated display case built for supermarket floor plans where space turns at a right angle. The Proxima NW45 Remote fits snugly into the junction of two runs, keeping chilled goods visible and accessible without breaking the refrigerated envelope. Because the refrigeration unit is external, the entire footprint is given over to display volume and the heat load is carried away from the sales floor, reducing ambient temperature and energy demand in the store itself. Refrigeration is dynamic: a fan circulates cold air across the evaporator coil and then through the display cavity. This forced convection evens out temperature gradients and prevents warm spots that can shorten shelf life. The coil is fed by an external compressor-condenser set charged with one of several modern refrigerants—R448 A, R449 A, R450 A, R407F, R404 A or R507—chosen for low global-warming potential and compatibility with existing supermarket systems. The case maintains a temperature band between +1 °C and +10 °C, suitable for dairy, deli meats, prepared salads and other perishables that must stay chilled but not frozen. The operator loads product from the front, sliding the telescopic glass panels upward on their silver aluminium tracks. Each panel can be held at any height, allowing staff to reach the back of the shelves without removing the glass. Once stocked, the panels close to form a continuous barrier that keeps cold air inside while still letting customers see the goods. LED lighting—available in white for general merchandise or pink for confectionery—illuminates the display cavity evenly, highlighting product colours and textures. To use the case, the operator sets the desired temperature on the electronic controller mounted on the side. The controller's digital display shows the current cavity temperature, and the built-in thermometer provides a secondary check. An automatic defrost cycle runs at intervals, melting any frost that has built up on the evaporator coil and draining the condensate away without manual intervention. The front glass is treated with an anti-fog coating, so it stays clear even when humidity is high. Construction is a mix of coated steel and stainless steel. The external housing and front panel are powder-coated steel, available in a range of colours to match store branding. The base is stainless steel with adjustable feet, allowing the unit to be levelled on uneven floors and spaced to accommodate large ventilation ducts. The worktop is also stainless steel, providing a durable surface for temporary storage or additional display. Inside, the display cavity is lined with coloured sheet metal, chosen to complement the store's colour scheme. Ecological polyurethane foam insulation fills the walls, floor and ceiling, minimising heat ingress and energy loss. The 230 V, 50 Hz electrical supply is standard for European commercial circuits, so the case can be connected without special wiring. The footprint—640 mm deep, 1170 mm wide and 1160 mm high—is designed to fit precisely into an inside corner, maximising display area while minimising the space taken from the sales floor. The weight, though not stated, is typical for a unit of this size and construction, meaning it can be moved with a pallet truck or forklift but is not easily shifted by hand. The stainless-steel worktop and coated-steel housing let you wipe down every surface with sanitiser without risking corrosion or paint damage during daily kitchen use. The stainless steel worktop and base can be wiped down with standard kitchen sanitiser. The coated steel housing and front panel are cleaned with mild detergent and water, avoiding abrasives that could damage the finish. The telescopic glass panels lift out for thorough cleaning, and the tracks should be wiped to remove dust and debris that could impede movement. The LED lighting is sealed, so it does not require maintenance beyond occasional dusting. The electronic controller and thermometer are surface-mounted and can be cleaned with a damp cloth, taking care not to let water enter the housing. The Proxima NW45 Remote is part of the Proxima line, which offers straight, corner and end-cap configurations. This inside-corner model is designed for external refrigeration only and cannot be converted to self-contained cooling. The catalogue places it in the refrigerated display section, under supermarket and large-format retail fixtures.