Dishwasher accessory Stalgast 815300

A cutlery basket holder secures perforated baskets in a commercial dish-washing sink or worktop cut-out. It sits flush under the rim, leaving the basket suspended in the wash water while the operator loads or unloads cutlery. Three round holes are sized to accept standard basket stems, preventing the basket from tipping or floating when it is lifted. The holder itself is fixed to the worktop with screws or clamps, so the basket remains steady during the wash cycle and does not drift into the spray arms.

To use the holder, the operator first fits it into the prepared 385 mm cut-out in the worktop. Once secured, the basket is lowered into the holes until the rim rests on the holder's surface. Cutlery is loaded into the basket, the wash programme is started, and the basket stays in place until the cycle finishes. After draining, the basket is lifted out by its handles, leaving the holder ready for the next load.

The unit is made of stainless steel, chosen for its resistance to water, detergents and repeated sterilisation. Its footprint of 385 mm by 150 mm matches standard worktop cut-outs in professional dishwashing stations, while the 180 mm height ensures the basket sits at a comfortable working level without obstructing the sink's tap or spray.

Cleaning is limited to wiping the holder's surface after each shift to remove detergent residue and food debris. No disassembly is required, and the stainless steel finish prevents staining or corrosion over time.

The catalogue places this article in the dishwashing accessories section, under cutlery handling equipment.