Wash and rinse arm assembly LF 3243486

A wash and rinse arm assembly distributes hot water and detergent across every rack in a professional dishwasher. Rotating jets spray from multiple angles, reaching the far corners of plates, cups and cutlery. The arm turns under water pressure, so no motor is needed; the same force that cleans also drives the movement. This method ensures even coverage without dead spots, removing soil in a single cycle rather than requiring pre-rinsing or repositioning.

The operator loads the dish racks as usual, closes the door and starts the programme. The arm begins to rotate as soon as the pump delivers water, spraying a fan of heated solution across the load. After the wash phase, a fresh rinse follows, using the same arm to distribute clean water and rinse aid. The sequence finishes with a final hot rinse that sanitises and speeds drying.

This assembly is constructed as a single replaceable unit, allowing quick swap-out during routine maintenance. It fits the specified dishwashers and glasswashers from AFI, EUROSYSTEM, HILTA, IME OMNIWASH, NOSEM, SAB ITALIA, SO.WE.BO., SOTAL, STORME and UNIC, matching the original mounting points and water connections.

Cleaning is limited to removing any debris that may block the jets. A soft brush or a rinse under running water restores full flow without disassembly. Regular inspection prevents scale build-up, which can slow rotation and reduce cleaning performance.

The catalogue places this article in the spare parts section for professional dishwashers and glasswashers.