Stand for equipment 700 Novameta OX0-PL1-50/70/50

A freestanding support that lifts catering appliances off the worktop and onto a level, stable platform. The stand does not move the equipment itself; it provides a rigid frame on which ovens, mixers, slicers or bain-maries sit. Four vertical legs transfer the weight directly to the floor, while cross-bracing stops the frame from twisting under uneven loads. Adjustable feet at each corner let the operator compensate for sloping floors, so the appliance stays level and does not rock during use.

The frame is welded into a single piece, so there are no loose joints to work loose over time. Each leg is a square stainless-steel tube that resists bending and corrosion. Anti-slip corners at the top of the legs prevent the appliance from sliding when the stand is nudged or when the floor vibrates. The shelf area is open, allowing air to circulate underneath the appliance and cables to pass through without pinching.

To set up, the operator places the stand where the appliance will sit, extends the adjustable feet until the frame is level, then lowers the appliance onto the anti-slip corners. The feet can be raised or lowered by turning them, giving a total adjustment range that accommodates most kitchen floors. Once the appliance is in place, the stand requires no further attention beyond occasional cleaning.

The frame is constructed from stainless-steel tube, welded at all joints. Adjustable feet are stainless steel with a non-slip pad. Anti-slip corners are fitted to each leg and measure 100 mm square.

The maximum load of 120 kg per shelf means the stand can support most countertop catering appliances without risk of bending or collapse. The footprint of 500 mm by 700 mm fits beneath standard worktop depths and leaves room for adjacent units. The height of 500 mm raises appliances to a comfortable working level, reducing strain on the operator's back and shoulders.

Cleaning is straightforward: wipe the stainless-steel surfaces with a damp cloth and mild detergent. The open frame design prevents dirt from collecting in corners, and the adjustable feet can be removed for thorough cleaning if needed.

The stand is available in a single size: 500 mm deep, 700 mm wide and 500 mm high.