Drain pump LF L5047109

A drain pump removes used water from the wash chamber and forces it into the building's waste system. In a commercial dishwasher or glasswasher, the pump sits at the lowest point of the machine, where water collects by gravity. When the wash cycle ends, the pump activates, drawing the water through a filter to trap debris, then pushing it up and out through the waste hose. Without this pump, the machine would flood or leave standing water that harms hygiene and the next load.

The operator does not interact directly with the pump; it runs automatically once the control board signals the end of a wash or rinse phase. After the machine stops, the pump continues for a short period to clear residual water, then shuts off until the next cycle.

This LF drain pump is constructed as a sealed unit with an electric motor and impeller housed in a corrosion-resistant casing. The design ensures quiet operation and long service life under continuous use in a busy kitchen.

The pump fits HOONVED dishwashers and glasswashers of the specified model ranges, providing a direct replacement for the original part. Installation requires disconnecting the waste hose and electrical connector, removing the old pump, and securing the new one in the same position.

Regular maintenance involves checking the waste hose for kinks or blockages and cleaning the filter that precedes the pump. These steps prevent back-pressure that could strain the pump and reduce its efficiency.