Drain pump LF 3122199

A drain pump removes used wash water from the machine and forces it into the building's waste line. In professional dishwashers and glasswashers, the pump sits at the lowest point of the tank, where it collects water that has passed through the wash cycle. An electric motor spins an impeller, creating suction that draws the water in and then pressure that pushes it up and out through the drain hose. Without this pump, water would pool inside the machine, preventing the next cycle from starting and risking overflow onto the kitchen floor.

The operator does not interact with the pump directly. Once the wash programme finishes, the machine's control board sends power to the pump, which runs until the tank is empty. The pump then switches off automatically, ready for the next load. The two mounting brackets supplied with this kit hold the pump securely against the chassis, preventing vibration that could loosen connections or damage the pump over time.

This LF Askoll drain pump kit is supplied as a complete unit with two mounting brackets. It is a direct replacement for the original pump in the listed models, requiring no modification to the machine. The kit fits AMIKA, APACH, COLGED, DEXION, ELETTROBAR, EUROWASH, IME OMNIWASH, MBM, PROJECT SYSTEMS and WOLK professional dishwashers and glasswashers.

Cleaning and upkeep follow from the pump's position and function. After each service day, the operator should check that the drain hose is clear and that the pump housing is free of debris. If the machine reports a drain fault, the pump is the first component to inspect; a blocked impeller or a loose bracket can stop the water from leaving the tank.

The catalogue places this item in the spare parts section under dishwasher components, specifically for drain systems.