Water mixer with two water inlets MONOLITH R0102010220

A single-lever tap that blends smooth water control with a compact footprint on the worktop. The round lever moves through a short, even arc, letting the operator set flow and temperature in one motion without overshooting or hunting for the right position.

The tap mixes hot and cold supplies internally, then delivers the blended stream through a fixed spout. No separate valves or diverters are needed; the lever itself opens, closes and adjusts the ratio of hot to cold. This keeps the worktop clear and speeds up filling pots, rinsing utensils or washing hands.

To use, lift the lever gently until water begins to flow. Tilt left for cold, right for hot, or leave it centred for a warm mix. Lower the lever to stop. The mechanism is sealed inside the body, so there are no exposed threads or washers to trap food debris or scale.

The body is mounted on two 18 mm tails spaced 150 mm apart, matching standard sink hole centres. Once the tails are inserted and the back-nuts tightened, the tap sits firmly without rocking or spinning. A rubber gasket under the base prevents water creeping beneath the worktop.

Construction is stainless steel throughout, chosen for resistance to corrosion and staining in hard-water areas. The lever and spout have a brushed finish that hides fingerprints and minor scratches from daily use.

The 300 mm spout height clears the rims of most commercial pots and containers, while the 18 mm tail diameter fits common supply pipes without reducers or adaptors.

Cleaning is limited to wiping the external surfaces with a damp cloth. The lever mechanism is self-lubricating and does not require periodic adjustment or greasing. If scale builds up inside the spout, a brief soak in a descaling solution restores full flow.

The tap is supplied as a single unit; no variants or additional parts are listed for this article.

Catalogue placement: commercial kitchen taps and fittings.