Stainless steel work table with sink and shelf Novameta BHS-PLA-60/60/85

A stainless steel worktable combines a food-safe work surface, a built-in sink and an undershelf in one rigid unit. The flat top gives a stable area for food preparation, plating or holding hot pans. The sink bowl is welded into the top so water and debris can be washed straight into it without spilling over the edge. An undershelf adds storage or staging space without taking extra floor area, keeping utensils and ingredients within arm's reach while the chef works.

The operator loads ingredients or equipment onto the top, fills the sink with water or ice as needed, and uses the undershelf to hold bowls, trays or cleaning supplies. When the sink is no longer required, it can be covered with a board to extend the work surface.

The table is constructed from stainless steel throughout. The top and sink are seamless, with rounded corners for hygiene. The undershelf is a flat sheet supported by a tubular frame that also forms the legs. Adjustable feet allow the unit to be levelled on uneven floors.

The sink measures 400 mm square and 250 mm deep, giving enough room for washing large pans or soaking sheet trays. The overall footprint is 600 mm by 600 mm, fitting into standard kitchen modules, while the 900 mm height matches most worktops and hobs for a continuous work line.

Cleaning is straightforward: the stainless steel surfaces can be wiped with detergent or sanitiser, and the sink drains completely when the plug is removed. The undershelf can be lifted off for thorough cleaning underneath if required.

The model BHS-PLA-60/60/85 is a single configuration; no variants are listed.