Modular shelf for furniture Novameta Z-M-DRAWER2-44/67/86

A worktop storage module built to hold kitchen essentials within arm's reach without cluttering the surface. Three plain drawers slide on full-extension runners, letting staff retrieve utensils, small equipment or ingredients without bending or stretching. The unit stands directly under the worktop, using vertical space that would otherwise be wasted, and keeps the workflow tidy and standardised across shifts. Each drawer is a separate compartment, so different items can be grouped by task or by frequency of use. The lowest drawer can store heavier tools, while the upper ones keep lighter, more frequently accessed items at eye level. The adjustable feet raise or lower the whole module to match the height of adjacent worktops, ensuring a continuous, level surface that meets hygiene and ergonomic standards. The sequence of use is straightforward: the operator pulls the drawer handle, loads or unloads the contents, and closes it. No doors swing open, so the module can be placed against a wall or between other units without losing access. The plain fronts give a clean, uniform look that fits any professional kitchen layout. The solid stainless-steel drawer fronts and runners shrug off steam, splashes and scrubbing brushes in a busy kitchen without warping or staining. The frame is welded for stability, and the feet are adjustable to compensate for uneven floors. No internal dividers or liners are included, so each drawer can be fitted with custom organisers as needed. The controls are limited to the drawer handles and the adjustable feet. The handles allow smooth opening and closing, while the feet are turned to raise or lower the module until it aligns with the worktop height. The 440 mm width means the module fits between standard worktop sections, taking up less than half a metre of linear space. The 670 mm depth matches typical worktop depths, so the module does not protrude into the aisle. The adjustable height of 825-890 mm allows it to sit flush with most worktops, creating a seamless run of preparation space. Cleaning is simple: the stainless steel surfaces are wiped down with a damp cloth and a mild detergent. The full-extension runners are accessible for occasional lubrication, and the plain fronts have no crevices where dirt can collect. The feet can be removed for thorough floor cleaning if necessary. The module is supplied as a single unit with three plain drawers. In the Novameta catalogue, this module is placed in the storage and organisation section, under worktop accessories.