Industrial mixer faucet MONOLITH EXTBF0050P

A fixed shower with mixer combines hot and cold water at the tap, delivering a steady stream at the temperature the operator sets. The hand shower directs the flow precisely where it is needed, rinsing pots, trays and work surfaces without splashing across the kitchen. A single lever controls both volume and temperature, so the operator can adjust the mix in one movement while the other hand holds the utensil under the spray. The sequence begins by turning the lever to the cold side to purge any residual hot water from the line. Once the flow runs cool, the lever is moved towards the hot side until the desired temperature is reached. The hand shower is then unclipped from its bracket and aimed at the item to be rinsed. After use, the shower is returned to its bracket and the lever closed fully to prevent drips. Construction is a fixed riser with a 155 mm hole spacing between the hot and cold inlets. This standardised spacing matches the pipe centres found in most commercial kitchens, so the unit drops straight onto the existing supply without adaptors or re-plumbing. The riser and mixer body are finished in a durable coating that resists the steam and grease of daily service. Its spray pattern is engineered to cover a wide area with even pressure, so large trays are rinsed quickly and without dead spots. The shower head clips securely into the bracket when not in use, keeping the worktop clear and the hose safely stowed. The brushed stainless-steel hose and solid brass body shrug off kitchen grease and steam so the mixer stays free of build-up without scrubbing. The mixer lever and shower head are wiped daily with a damp cloth to remove grease and limescale. The hose is unclipped and rinsed through weekly to clear any debris that may have entered the spray nozzles. The fixed riser and bracket are cleaned with a mild detergent, avoiding abrasives that could damage the finish. The unit is listed in the catalogue under Commercial Kitchen Taps and Showers.