Industrial mixer faucet MONOLITH EXTBF0042

A two-hole water mixer delivers both hot and cold water through a single spout by blending the supplies at the tap. Separate valves control each stream, allowing the operator to adjust temperature and flow without moving between separate taps. The mixer's spout swings to direct water into pots, sinks or containers of different sizes, reducing splashing and improving access around the worktop.

The operator turns the round handles to open or close the hot and cold valves. Each handle moves independently, so the user can fine-tune the mix by feel. The spout's 300 mm reach and 18 mm diameter give a steady, controlled stream that fills large vessels quickly while keeping the work surface dry.

Built for professional kitchens, the mixer has a fixed 155 mm spacing between the mounting holes. This standardised distance matches most commercial worktops and pre-drilled sink units, so installation requires only two holes and the supplied fixings. The body and spout are formed in one piece to eliminate leaks at joints, and the handles are secured with concealed fixings for a clean, durable finish.

Cleaning is limited to the external surfaces. The smooth, rounded handles and spout can be wiped with a damp cloth to remove water marks and grease. The fixed spout and concealed fixings prevent dirt from collecting in crevices, so upkeep is minimal.

The catalogue places the EXTBF0042 in the taps and mixers section, under worktop-mounted water controls.