Glass door, complete Tefcold SpareParts 12269

A glass door assembly for a backbar cooler keeps bottled goods and beverages chilled while allowing full visibility of stock. The design relies on a sealed unit that combines two or more toughened glass panels separated by an insulating air gap. This gap slows the transfer of heat from the surrounding air into the cabinet, so the compressor does not have to cycle as often to hold the set temperature. Around the edge of the door, a magnetic gasket presses tightly against the cooler's frame when the door closes, sealing the cold air inside and blocking warm air from entering. The result is a steady internal climate that reduces energy use during service without sacrificing display clarity.

To fit the assembly, align the hinge side with the existing brackets on the cooler. Secure the hinge pins or screws so the door hangs level and swings freely. Adjust the magnetic gasket until it compresses evenly against the cabinet frame, closing any gaps that could let cold air escape. Once installed, the door should open and close smoothly, with the magnetic seal holding it firmly until it is deliberately pulled open.

The assembly is supplied as a single unit: the glass panels are pre-bonded into a metal or plastic frame. This construction allows the entire door to be removed and replaced without taking apart individual components. The glass is toughened for impact resistance, and the frame materials are chosen to resist corrosion in the humid environment of a bar.

This door is a direct replacement for the Tefcold BA15H-I backbar cooler only. It does not fit any other model or brand, even if the external dimensions appear similar. Verify the article number 12269 before ordering to confirm compatibility.