Counter refrigerator table without drawers GEMM 40202437

A refrigerated table keeps prepared ingredients chilled at the workstation, eliminating trips to a remote cold room. The system circulates cold air through a ventilated evaporator, pulling heat from the stored food and expelling it at the condenser. This continuous cycle maintains a uniform temperature across every shelf, preventing warm spots that could compromise safety or texture. The refrigerant absorbs heat inside the cabinet and releases it outside, allowing the unit to hold food just above freezing without freezing it solid.

The operator loads GN 1/1 gastronorm containers directly onto the internal shelves, then sets the desired temperature between -2 °C and +8 °C on the digital touch panel. Once the temperature is reached, the fan-driven cooling system keeps it steady, while an automatic defrost cycle melts any ice build-up on the evaporator coils. Condensate is collected and evaporated by a heating element, so no external drain is required. The unit can be positioned against a wall or island, with the technical compartment on either side to fit the kitchen layout.

The cabinet is built from stainless steel throughout, including the 10/10 grade worktop that resists scratches and corrosion under daily use. A 50 mm insulation layer reduces heat transfer, cutting energy consumption while maintaining stable internal temperatures. The 2.8-inch touch control panel displays the current temperature and allows adjustments without opening the door, preserving the cold chain.

The table runs on a 230 V single-phase supply, drawing 0.405 kW and consuming 2.07 kWh over 24 hours. Its 1760 mm width, 700 mm depth and 850 mm height create a footprint that fits standard kitchen worktops, while the 143 kg weight ensures stability without anchoring. The unit is classified as Climate Class 5, meaning it maintains performance in ambient temperatures up to +40 °C, and Energy Efficiency Class B, reflecting its balance of cooling capacity and power use.

Each door is supplied with one GN 1/1 shelf, and additional shelves or drawers can be specified at ordering. The table is prearranged for plinth installation, allowing the worktop height to be adjusted to match adjacent equipment. Cleaning involves wiping the stainless-steel surfaces with a mild detergent, while the automatic defrost and condensate removal reduce the need for manual drainage maintenance.